Medium Cut Compound

Description

Car-Chem Medium Cut Compound is our intermediate of 3 stages of cutting compounds.

Developed in-house by our technical department. Our Medium Cut Compound is formulated with diminishing abrasive chemistry. This means the particles of abrasive start off large, getting smaller the more you work with them. In effect lowering the cutting power over time. It also contains the highest grade of fillers and kaolin clays to help refine, restore and cleanse the vehicles paintwork.

Car-Chem Medium Cut Compound is designed as a refining stage of polishing. It will help to even out the deeper cuts of our Heavy Cut Compound in preparation for our Light Cut Compound.

How To Use (Hand Application):

1. Apply 2-5 pea sized amounts of compound to a clean, lint-free microfibre or a foam applicator pad.
2. Using light pressure;  spread the compound onto the vehicles paintwork, working in small areas (50cm x 50cm) using an up/down and left/right lattice pattern for optimal coverage.
3. Allow the compound to dry to a haze.
4. Buff off with a clean, lint-free microfibre.

How To Use (Machine Application):

1. Apply 2-5 pea sized amounts of compound to a light foam polishing pad.
2. Using light pressure and the lowest speed setting;  spread the compound onto the vehicles paintwork.
3. Work in small areas (50cm x 50cm) using an overlapping up/down and left/right lattice pattern for optimal coverage.
4. Increase the speed setting to a maximum of 1000RPM and continue to work the compound into the paintwork until the polish becomes clear.
5. Allow the compound to dry to a haze.
6. Buff off with a clean, lint free microfibre.

Top Tip:

Ensure you are working out of direct sunlight whenever you are using a polishing compound, and check that your vehicle is cool to the touch prior to application. For best results use our Prep Panel Wipe between each stage of cutting to remove any unwanted contaminants.